St. Louis Ribs
- 4 racks spareribs
- 1 recipe Rib Marinade (page 21)
- 3 cups Jacks Old South Original Rub, or 1 recipe Basic Barbecue Rub (page 20)
- 1 recipe Rib Spritz (page 73)
- 1 cup apple juice
- 1 recipe Hog Glaze (page 23)
- A cutting board
- Sharp boning knife or paring knife
- Paper towels or clean kitchen towels
- One at a time, place the slabs of spareribs on the cutting board, bone side down.
- Trim off the excess fat from the first three ribs.
- Turn the slab over.
- Peel off the thick membrane (or silver, as its sometimes called) that covers the ribs.
- This silver prevents rubs and other seasonings from adhering to the rib rack and doesnt allow a marinade or smoke to penetrate the meat, so its important to get rid of it.
- The easiest way to remove the membrane is by making a small incision just below the length of the breastbone.
- Work your fingers underneath the membrane until you have 2 to 3 inches cleared.
- Grab the membrane with a towel (which just gives you a better purchase on it) and gently but firmly pull it away from the ribs.
- Pulling off the membrane exposes loose fat that will need trimming, so take your knife and cut out any excess fat.
- The last step is doing the St. Louis cut, which ensures that the ribs will be uniform in size.
- Use your boning knife to separate the ribs from the breastbone: Pick the longest bone near the breastbone and use it as a guideline of where to make a horizontal cut along the length of the slab.
- You should end up with two slabs of ribs that are 5 or 6 inches in length.
- They wont be curved like the baby backsthats not how these bones are; theyre straight up.
- After the ribs are properly trimmed, set the racks in an aluminum baking pan and cover them completely with the rib marinade.
- Cover the pan with aluminum foil and let it sit for 4 hours, either in the refrigerator or, if youre at a contest or in a picnic situation, in a cooler packed with ice.
- When you are ready to cook them, remove the ribs from the marinade.
- Pat them dry with towels.
- Apply the rub lightly around the edges of the ribs, over the back side of them, and on top.
- Then let the ribs sit, uncovered, at room temperature for 30 minutes.
- In the meantime, heat a smoker to 275 F.
- Put the ribs in a baking pan, put it in the smoker, and cook for 3 hours.
- After the first 45 minutes of cooking, spritz the ribs.
- Continue to spritz at 15-minute intervals for the duration of the cooking time.
- (The ribs should be uncovered so they can absorb as much smoke as possible.)
- Remove the pan from the smoker.
- Pour the apple juice into a clean aluminum pan.
- Place the ribs in the pan, bone side down, and cover the pan with aluminum foil.
- Place the pan in the smoker and cook for 2 hours.
- Remove the pan from the smoker and shut off the heat on the smoker.
- Remove the foil, and apply the glaze to the top and bottom of the slabs of ribs.
- Re-cover the pan with foil, return it to the smoker, and let the ribs rest in the smoker for 1 hour as the temperature gradually decreases.
- Remove the ribs from the pan and let them rest for 10 minutes on a wooden cutting board.
- Then cut and serve.
spareribs, marinade, south original rub, apple juice, cutting board, boning knife, paper
Taken from www.epicurious.com/recipes/food/views/st-louis-ribs-378524 (may not work)