Puerto Rican Roast Pork Shoulder

• One 4 1/2-pound skin-on pork shoulder roast
• Wet Rub for Meats and Poultry

1. Up to 3 days before you serve the roast, set it in a bowl, skin side up.
2. With a paring or boning knife, make several slits about 1/2 inches apart through the skin of the roast and into the meat.
3. Make the slits as deep as you can.
4. Wiggle a finger in the slits to open them up a bit and then fill each one with wet rub using a teaspoon.
5. (A pair of latex gloves comes in handy when it comes time to rub the wet rub into the pork.)
6. Do the same on all sides.
7. If you have rub left over, smear it all over the outside of the roast.
8. Refrigerate, covered, at least 1 day or up to 3 days.
9. Preheat the oven to 450F.
10. Set the roast, skin side up, on a rack in a roasting pan.
11. Roast for 1 hour, turn the heat down to 400F, and roast until the skin is a deep golden brown and crackly and with no trace of pink near the bone, about 1/2 hours or until an instant reading thermometer inserted near the bone registers 160F.
12. Let the roast rest at least 15 minutes before carving.
13. To serve, remove the crispy skin.
14. It will pull right off in big pieces.
15. Cut them into smaller pieceskitchen shears work well for thisand pile them in the center of the platter.
16. Carve the meat parallel to the bones all the way down to the bone.
17. (It will get trickier to carve neat slices as you get near the bone; dont let that bother you.)

pork shoulder roast, rub

Taken from www.cookstr.com/recipes/puerto-rican-roast-pork-shoulder (may not work)