Cake Pops Recipe
- 4 cups cake crumbs (about 14 ounces)
- 1/4 cup frosting (not whipped cream frosting), at room temperature
- 1/2 cup sanding sugar
- 8 ounces Candy Melts
- Vegetable oil, as needed
- 16 (6-inch) lollipop sticks (see Special Equipment note)
- Line a baking sheet with parchment paper; set aside.
- Place the cake crumbs and frosting in a large bowl and mash them together with a spoon just until a dense, moist dough forms and the frosting is evenly incorporated with no visible lumps.
- Using your hands, roll the mixture into 16 (1-1/2-inch) balls (about the size of a ping-pong ball) and place them on the prepared baking sheet.
- Place the baking sheet in the freezer until the cake balls are firm but not frozen, about 30 minutes.
- Meanwhile, line a second baking sheet with parchment paper.
- Place the sanding sugar in a small bowl and set it and the baking sheet aside.
- When the cake balls are ready, place the Candy Melts in a medium microwave-safe bowl and microwave on high, stirring every 30 seconds, until melted and smooth.
- (The mixture should be the consistency of softly whipped cream.)
- If its too thick, add vegetable oil, 1/2 teaspoon at a time, until it reaches the desired consistency.
- (Alternatively, fill a medium saucepan with 2 inches of water and bring it to a boil over high heat.
- Reduce the heat to low so the water is just simmering.
- Place the Candy Melts in a heatproof bowl large enough to sit over the water without touching it.
- Stir until melted.)
- Remove 2 of the cake balls from the freezer.
- Dip 1/2 inch of a lollipop stick into the melted candy, then insert it about 1 inch into a cake ball.
- (The melted candy coating helps the cake ball stay on the stick.)
- Immediately dip the cake ball into the melted candy and turn to coat completely.
- Gently tap and twirl the stick several times on the edge of the bowl to form a thin, even coating, letting the excess drip off.
- Immediately dip the cake pop into the sanding sugar, turn to coat, and sprinkle additional sugar as needed to coat the pop completely.
- Hold the cake pop upright until the coating starts to set, about 30 seconds to 1 minute.
- Place on the second prepared baking sheet.
- (Dont worry, the coating will be set enough that the pops will retain their round shape after you lay them down.)
- Repeat with the second cake ball, then repeat with the remaining cake balls, coating 2 at a time.
- (If the melted candy starts to cool and thicken, reheat until its melted again.)
- Let the cake pops sit at room temperature until the candy coating is completely set and hardened, about 15 minutes.
- Store at room temperature in an airtight container for up to 1 week.
cake crumbs, frosting, sanding sugar, melts, vegetable oil
Taken from www.chowhound.com/recipes/cake-pops-30434 (may not work)