Mexican Charra Beans

  1. Clean the dried beans, wash and drain them. Place in a large heavy saucepan. Add the water, bouillon and bay leaves. Simmer uncovered over low heat.
  2. After 1 hour, stir the beans and check the water level. If the water doesn't cover the beans by an inch, add enough hot water to do so. Check water level again in 30 minutes, and add more hot water to maintain the 1-inch above beans level.
  3. In a small skillet cook the bacon until brown. Remove the bacon and reserve, leaving the drippings in the skillet. Add the onion, garlic and jalapenos to the drippings and cook until tender. Stir in canned tomatoes and cook about 5 minutes.
  4. Add the cooked vegetables to the beans and continue cooking. Check beans every 15 minutes, keeping water level just above the beans. When beans are fully cooked, there should be extra liquid, but the beans should not be watery. If too watery, take about 1/2 to 1 cup of beans, mash them, and add them back to the pot of beans, bringing them to a boil to thicken the bean liquid somewhat. Stir in the cilantro and reserved bacon just before the beans are done.

pinto beans, water, beef bouillon, bay leaves, bacon, onion, garlic, fresh jalapeufo chilies, tomatoes, salt, fresh cilantro, chilies

Taken from www.epicurious.com/recipes/member/views/mexican-charra-beans-50032110 (may not work)

Another recipe

Switch theme